- How do I know if my chainsaw chain is worn out?
- Should you smoke a chainsaw?
- What should you not do with a chainsaw?
- Is it bad to run a chainsaw out of gas?
- Why does my chainsaw get dull so fast?
- Will a chainsaw run without bar oil?
- Is it bad to cut wet wood with a chainsaw?
- Why is my chainsaw blade smoking?
- Should you run a chainsaw at full throttle?
- Can a chainsaw overheat?
- Should I run my chainsaw dry?
- Will dirt dull a chainsaw?
How do I know if my chainsaw chain is worn out?
The signs that it’s time for chainsaw chain replacement#1 – Difficulty with positioning.
#2 – The chainsaw no longer pulls itself into the wood.
#3 – Smoking, even when lubrication is good and chain tension is correct.
#4 – Crooked cuts.
#5 – Missing or damaged teeth.
Should you smoke a chainsaw?
It isn’t normal for a chainsaw to smoke, but if it does happen it can be the result of the chainsaw overheating, the fuel mix containing too much oil, or the chain either not being sharp enough or not getting enough lubrication. In short, a smoking chainsaw is a sure sign that something isn’t right.
What should you not do with a chainsaw?
Don’t ever run while carrying a chainsaw. Do try to avoid cutting with the blade tip, this will also help avoid kickback. Do try cut below shoulder height wherever possible. This will keep a chainsaw away from your face in the event of kickback.
Is it bad to run a chainsaw out of gas?
As long as the saw is not under a load, no damage will be done. If done while cutting, it could run lean at the end and over time cause cylinder and piston damage.
Why does my chainsaw get dull so fast?
You may be putting to steep of an angle on the cutters, which will dull quickly. You’re rakers may be too far down, which will contribute to a quick dulling chain. You may be cutting dirty wood. You may be slightly touching the ground with the tip of the bar.
Will a chainsaw run without bar oil?
Running a chainsaw without bar oil will cause mechanical problems, and some serious safety issues, such as: Kickback. Chain breaking. Dulls the chain.
Is it bad to cut wet wood with a chainsaw?
In all honesty, no! The additional moisture found on wet wood will not make any difference to the cutting process. It doesn’t place any additional resistance on the chainsaw, and no additional effort is required to cut through it.
Why is my chainsaw blade smoking?
While a chain saw does produce some heat while in use, it should never overheat or begin smoking. … The most likely causes of smoking and overheating are a lack of air and/or a lack of lubrication to the engine or the chain saw chain guide bar.
Should you run a chainsaw at full throttle?
Good practice to run full throttle most all of the time. There may be some instances where you want to feather the throttle for a fine cut or finishing a bucking cut to not hit the dirt or what have you. That’s fine just don’t make anything less than full throttle the norm.
Can a chainsaw overheat?
Chainsaw engines run at high temperatures, usually in the summer, so they can quickly overheat. … If dust, wood chips or other material blocks these systems, the engine will start to overheat. The engine also needs to expel hot air, so the muffler must also be kept clean to keep the engine from overheating.
Should I run my chainsaw dry?
Never run your chainsaw dry. You should instead use a quality gas stabilizer. A stabilizer will keep your fuel fresh and protect your fuel system from damage caused by stale gas.
Will dirt dull a chainsaw?
Nobody plans to run their chain saw into dirt. But when you cut close to the ground, you’re just begging for a quick dip into dirt, rocks and crud. All it takes is a second in the dirt to dull the cutters. In addition to dulling the cutters, dirt also wears out the chain links faster, causing the chain to stretch.